Honda HRS216PKA Manual page 83

FLYWHEEL / IGNITION COIL
STOP SWITCH WIRE ROUTING
Be sure the stop switch wire is routed between the engine
stop switch and the ignition primary coil as shown before
installing the flywheel.
INSTALLATION
1. Make sure the flywheel taper is free of dirt, oil, grease,
and other foreign material before installation.
2. Make sure there is no foreign material on the magnets.
3. Be sure the woodruff key is set in the keyway properly.
4. Install the flywheel.
5. Hold the flywheel with the special tool and tighten the
14 mm special nut with a torque wrench.
TORQUE: 52 N•m (38 ft-lb)
6. Remove the strap or equivalent material from the
flywheel brake lever.
7. Install and adjust the ignition coil
8. Install the fan cover/fuel tank
9. Reconnect the spark plug cap.
10. Check the operation of the flywheel brake
8-4
(P. 8-5).
(P. 7-17).
(P. 3-11).
HRS216PKA • HRS216SKA • HRS216VKA
ENGINE STOP
SWITCH
SPECIAL NUT, 14 mm
52 N•m (38 ft-lb)
TORQUE WRENCH

FLYWHEEL HOLDER
07APB-Z28A100