Advertisement
Display shows "VAT EMPTY" "YES NO". Verify that vat is empty, and press "✓"
6 6 ) )
button.
Display shows "CLEAR OLD OIL FROM OIL LINES" "✓=PUMP" "X=DONE".
7 7 ) )
Press and hold "✓" button for a few seconds to clear old oil from lines. Once
cleared, press "X" button.
Display shows "CLN VAT COMPLETE" "YES NO". Once vat is clean, press "✓"
8 8 ) )
button and display shows "CLOSE DRAIN". Push in the drain knob.
Display shows "MANUAL FILL VAT", followed by "IS POT FILLED?" "YES NO".
9 9 ) )
Fill vat to the lower indicator line on the rear of vat. See
page
18. Press "✓" button and fryer returns to normal operation.
Remove discard shuttle from under fryer and replace with the filter pan
1 1 0 0 ) )
assembly.
3 3 . . 1 1 2 2 . . 2 2 D D i i s s c c a a r r d d i i n n g g O O i i l l U U s s i i n n g g O O p p t t i i o o n n a a l l B B u u l l k k O O i i l l D D i i s s p p o o s s e e S S y y s s t t e e m m
Connect female quick disconnect attached to the hose at the rear of fryer, to the
1 1 ) )
correct male quick disconnect at the wall. Once attached, the hose can remain
connected unless the fryer is moved.
NOTE: "BULK OIL DISPOSE?" in the Special Program Mode or Set-Up Mode, must to
set to "YES" for the Bulk Oil Dispose System to operate. Also, a password code step
(1, 2, 3) can be added in Special Programming, SP-27.
Press and hold the filter button until display shows "*FILTER MENU*" "1.
2 2 ) )
EXPRESS FILTER?".
Press and release right arrow twice until display shows "3.DISPOSE". Press "✓"
3 3 ) )
button; display shows "DISPOSE?" "YES NO", or enter code 1, 2, 3, if SP-27 is
3.3 Filling Or Adding Oil ,
27
Advertisement
