Remote Control Commands - Brother MFC-4550 Operation Manual

MFC 4550/6550MC/7550MC
OP-US-5.0
MESSAGE CENTER MODE SETTINGS

Remote Control Commands

You can program and control your MFC with remote control commands.
Remote control commands
91 Playing voice messages
1 Z (Skip back)
2 X (Skip next)
9 STOP Playing
92 Record Memo
93 Erase all ICM & Memo
94 Play and Record OGM
in memory
1 Play 1 MSG
2 F/T OGM
2 Record 1 MSG
2 F/T OGM
95 Changing Fax Forwarding
/Paging setting
1 O F F
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
5 FWD NO.
96 Retrieve FAX
1 Memory Status List
2 00 Retrieve all FAX
2 <MSG No.> 00
Retrieve by MSG
number
3 Erase FAX in the
memory
97 Check the receiving status
1 F A X
2 VOICE
98 Change Answer Mode
1 MSG CTR
2 F/T
3 F A X
90 Exit
9-26
After one long beep, the machine plays ICM, Memo and Voice Alarm.
Press 1 while listening to an ICM, Memo or Voice Alarm message to play
it again. If you press 1 before a message, you will hear the previous
message.
While playing ICM, Memo and Voice Alarm, you can skip to next
message.
Stop playing ICM, Memo and Voice Alarm.
After one long beep, you can record a memo. You can stop recording by
pressing 9.
If you hear one long beep, the erase is accepted. If you hear three short
beeps, you can not erase because all voice messages have not been played,
or there is no voice message to erase.
*This code erases all recorded messages, not one by one.
The machine plays the selected OGM. You can stop playing OGMs by
CTR OGM
pressing 9.
After one long beep, you can record the selected OGM. You will hear the
CTR OGM
OGM message played once. You can stop recording the message by
pressing 9.
If you hear one long beep, the change is accepted. If you hear three short
beeps, you can not change it because the conditions (ex. registering
paging number) have not been completed. You can register your fax
forwarding number by using 4. FAX FWD NO (see page 9-27). Once you
have registered the number, the machine will automatically turn to "FAX
FWD:ON" mode. Then retrieve a Memory Status List by entering 961
(see page 9-27). After you make sure that the Fax Forwarding number
you registered is correct in the List, enter the confirmation command 955.
Now the machine will start Fax Forwarding.
CONFIRM
You must call from a remote fax machine to receive the Memory Status
List or stored fax messages. (See page 9-27.)
If you hear one long beep, you can erase the fax message from the
memory.
You can check whether your MFC has received any FAX or VOICE
messages. If yes, you will hear one long beep. If no, you will hear three
short beeps.
If you hear one long beep, you can change the answer mode. If you hear
three short beeps, you can not change it. (Example: There is no MSG CTR
OGM when you want to change to MSG CTR mode.)
REMOTE RETRIEVAL
Detail Operation