Remote Control Commands; Detail Operation - Brother MFC-730 Owner's Manual

M E S S A G E M A N A G E R ( O N L Y F O R M F C - 7 4 0 )

Remote Control Commands

Follow the commands below to access features remotely. When you call
the MFC and enter your Remote Access Code (The factory setting is
159 ), the system will signal you with two short beeps to enter a remote
control command.
Remote control commands
91 Playing voice messages
1 { (Skip back)
2 } (Skip next)
9 STOP Playing
92 Record Memo
93 Erase all ICM & Memo
94 Play and Record OGM in
memory
1 Play 1 TAD MSG
2 F/T MSG
3 PAGING MSG
2 Record 1 TAD MSG
2 F/T MSG
3 PAGING MSG
95 Changing Fax Forwarding/
Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
96 Retrieve Fax
1 Memory Status List
2 Retrieve all Fax
3 Erase Fax in the
memory
97 Check the receiving status
1 Document
2 Voice
98 Change Answer Mode
1 TAD
2 Fax/Tel
3 Fax
90 Exit

Detail Operation

After one long beep, the MFC plays ICM and Memo.
Press 1 while listening to an ICM or Memo to play it again. If you press
1 before a message, you will hear the previous message.
While playing ICM and Memo, you can skip to next message.
Stop playing the ICM and Memo.
After one long beep, you can record a memo. You can stop recording by
pressing 9.
If you hear one long beep, the erase is accepted. If you hear three short
beeps, you cannot erase because all voice messages have not been
played, or there is no voice message to erase.
*This code erases all recorded messages, not one at a time.
The MFC plays the selected OGM. You can stop playing OGMs by
pressing 9.
After one long beep, you can record the selected OGM. You will hear the
message played once. You can stop recording the message by pressing 9.
If you hear one long beep, the change is accepted. If you hear three short
beeps, you cannot change it because the conditions have not been met
(Example: registering paging number).
You can register your fax forwarding number by using
4. FAX FWD NO (See "Changing Fax Forwarding Number" in this
chapter). Once you have registered the number, the MFC will
automatically turn to FAX FWD:ON mode. Then retrieve a Memory
Status List by entering 9 6 1 to make sure that the Fax Forwarding
number you registered is correct in the List.
Enter the number of a remote fax machine to receive a report or stored
fax messages. (See "Retrieving the Memory Status List" and "Retrieving
Fax Messages".)
If you hear one long beep, you can erase the fax message from the
memory.
You can check whether your MFC has received any Document or Voice
messages. If yes, you will hear one long beep. If no, you will hear three
short beeps.
If you hear one long beep, you can change the answer mode. If you hear
three short beeps, you cannot change it. (Example: There is no TAD
MSG when you want to change to TAD mode.)
After a long beep, you can exit remote control.
111