Stihl BR 800 Service Manual page 44

12
Position the throttle cable (12) in the guides (arrows)
N
in the handle molding (2) and check the following
points:
Installed position of throttle cable (12):
–
1. Black wire
2. Yellow wire
3. Bowden cable
Lubricate web (19) in handle molding (2) with STIHL
N
multipurpose grease 0781 120 1110.
Push blade receptacle of black wire onto the contact
N
spring (11) so that its closed side faces the contact
spring (11).
Push the black wire with contact spring (11) into the
N
guides (arrows) in the handle molding (2).
21
12
Push flag terminal of yellow wire onto the pivot (20) so
N
that its closed side faces the contact spring (11).
Push yellow wire (11) into guides (arrows) in the
N
handle molding (2).
Fit the setscrew (5) in the throttle lever (4).
N
Lubricate opening (21) in lever (9) with STIHL
N
multipurpose grease 0781 120 1110.
42
11
19
2
2
20
11
10
9
Fit the lever (9) in the throttle lever (4).
N
Attach nipple of throttle cable (12) to hole (21) in lever
N
(9).
Place the throttle lever (4) with lever (9) in the handle
N
molding (2).
4
Fit the torsion spring (6) on the pivot pin so that its
N
short leg locates against the handle molding (2).
Hook the long leg of the torsion spring (6) on the lever
N
(9).
Fit the spring (11) on the cam (10).
N
Push cam (10) together with spring (3) onto setting
N
lever (1) as far as stop.
Push setting lever (1) in direction of "0" and check that
N
the contact spring touches the yellow wire's flag
terminal.
Depress the lockout lever (8) and fit the throttle lever
N
(11) so that it engages the lockout lever (8).
2
12
7
Place handle molding (7) on handle molding (2).
N
Insert and tighten down the screws (8a) firmly.
N
3
2
6
10
9
8a
8b
18
BR 800