Configuring A Login Banner - Cisco Catalyst 9400 System Management Configuration Manual

Administering the Device
Step 4
Step 5
Step 6

Configuring a Login Banner

You can configure a login banner to be displayed on all connected terminals. This banner appears after the
MOTD banner and before the login prompt.
Follow these steps to configure a login banner:
Procedure
Step 1
Step 2
Step 3
Command or Action
end
Example:
Device(config)# end
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
banner login c message c
Example:
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Configuring a Login Banner
Purpose
message Enters a banner message up to 255
characters. You cannot use the delimiting
character in the message.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the
configuration file.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the login message.
c Enters the delimiting character of your
choice, for example, a pound sign (#), and press
25