Cisco Catalyst 9400 System Management Configuration Manual page 216

Creating a Flow Exporter
Step 21
Creating a Flow Exporter
You can create a flow exporter to define the export parameters for a flow.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
198
Command or Action
end
Example:
Device(config)# end
Command or Action
configure terminal
Example:
Device# configure terminal
flow exporter flow_exporter_name
Example:
Device(config)# flow exporter
flow-exporter-1
description description
Example:
Device(config-flow-exporter)# description
flow-exporter-1
destination { hostname | ipv4-address |
ipv6-address }
Example:
Device(config-flow-exporter)# destination
10.10.1.1
option application-table [ timeout seconds
]
Example:
Device(config-flow-exporter)# option
application-table timeout 500
end
Example:
Device(config)# end
show flow exporter
Example:
Device# show flow exporter
Configuring Application Visibility and Control in a Wired Network
Purpose
Returns to privileged EXEC mode.
Alternatively, you can also press Ctrl-Z to exit
global configuration mode.
Purpose
Enters global configuration mode.
Enters flow exporter configuration mode.
(Optional) Creates a description for the flow
exporter.
Specifies the hostname, IPv4 or IPv6 address
of the system to which the exporter sends data.
(Optional) Configures the application table
option for the flow exporter. The timeout option
configures the resend time in seconds for the
flow exporter. The valid range is from 1 to
86400 seconds.
Returns to privileged EXEC mode.
Alternatively, you can also press Ctrl-Z to exit
global configuration mode.
Displays information about all the flow
exporters.