Monitoring And Maintaining Sdm Templates - Cisco Catalyst 9400 System Management Configuration Manual

Monitoring and Maintaining SDM Templates

Step 2
Step 3
Step 4
Step 5
Monitoring and Maintaining SDM Templates
Verifying SDM Templates
Use the following commands to monitor and maintain SDM templates.
Command
show sdm prefer
reload
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
252
Command or Action
configure terminal
Example:
Device# configure terminal
sdm prefer { access | core | | }
Example:
Device(config)# sdm prefer access
end
Example:
Device(config)# end
reload
Example:
Device# reload
Configuring SDM Templates
Purpose
Enters global configuration mode.
Specifies the SDM template to be used on the
switch. The keywords have these meanings:
• access —Sets the switch to the Access
template.
• core —Sets the Core template.
Note The no sdm prefer command and
a default template is not supported.
Returns to privileged EXEC mode.
Reloads the operating system.
After the system reboots, you can use the show
sdm prefer privileged EXEC command to
verify the new template configuration. If you
enter the show sdm prefer command before
you enter the reload privileged EXEC
command, the show sdm prefer command
shows the template currently in use and the
template that will become active after a reload.
Purpose
Displays the SDM template in use.
Reloads the switch to activate the
newly configured SDM template.