Setting Up A Connection To Cssm - Cisco Catalyst 9400 System Management Configuration Manual

Smart Licensing Using Policy
Step 25
Step 26

Setting Up a Connection to CSSM

The following steps show how to set up a Layer 3 connection to CSSM to verify network reachability. Steps
marked as "(Required)" are required for all product instances, all other steps may be required or optional,
depending the kind of product instance and network requirements. Configure the applicable commands:
Procedure
Step 1
Step 2
Step 3
Command or Action
end
Example:
Device(config)# end
show ip http server session-module
Example:
Device# show ip http server
session-module
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
{ip|ipv6}name-server server-address 1
...server-address 6]
Example:
Device(config)# ip name-server
209.165.201.1 209.165.200.225
209.165.201.14 209.165.200.230
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Setting Up a Connection to CSSM
Purpose
Exits the global configuration mode and enters
priveleged EXEC mode.
(Required) Verifies HTTP connectivity. In the
output, check that is active.
SL_HTTP
Additionally, you can also perform the
following checks :
• From device where CSLU is installed,
verify that you can ping the product
instance. A successful ping confirms that
the product instance is reachable.
• From a Web browser on the device where
CSLU is installed verify
https://<product-instance-ip>/
ensures that the REST API from CSLU
to the product instance works as expected.
Purpose
Enables privileged EXEC mode. Enter your
password, if prompted.
Enters global configuration mode.
Specifies the address of one or more name
servers to use for name and address resolution.
You can specify up to six name servers.
Separate each server address with a space. The
first server specified is the primary server. The
device sends DNS queries to the primary server
first. If that query fails, the backup servers are
queried.
. This
147