Cisco Catalyst 9400 System Management Configuration Manual page 227

Configuring Application Visibility and Control in a Wired Network
Class-map: class-default (match-any)
Show Commands for Viewing Attributes-based QoS Configuration
show policy-map interface
Displays the attribute-based QoS statistics and the configured policy maps on all interfaces.
The following is a sample output for the policy-maps configured on all the interfaces:
Device# show policy-map interface gigabitEthernet 1/0/2
GigabitEthernet1/0/2
Service-policy input: attrib--rel-types
Class-map: rel-relevant (match-all)
Class-map: rel-irrelevant (match-all)
Class-map: rel-default (match-all)
Class-map: class-default (match-any)
show ip nbar protocol-attribute
Displays all the protocol attributes used by NBAR.
The following shows sample output for some of the attributes:
Device# show ip nbar protocol-attribute cisco-jabber-im
0 packets, 0 bytes
30 second rate 0 bps
Match: protocol ms-lync-video
0 packets, 0 bytes
30 second rate 0 bps
QoS Set
dscp af41
34 packets
Match: any
20 packets
Match: protocol attribute business-relevance business-relevant
QoS Set
dscp ef
0 packets
Match: protocol attribute business-relevance business-irrelevant
QoS Set
dscp af11
14 packets
Match: protocol attribute business-relevance default
QoS Set
dscp default
0 packets
Match: any
Protocol Name : cisco-jabber-im
encrypted : encrypted-yes
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Examples: Application Visibility and Control Configuration
209