Configuring A License - Cisco Catalyst 9400 System Management Configuration Manual

Smart Licensing Using Policy
Step 5
Step 6
Step 7

Configuring a License

In the Smart Licensing Using Policy environment, you can use this task to change the license level being used
on the product instance, or to additionally configure an add-on license on the product instance. For example,
if you are currently using Network Advantage and you also want to use features available with a corresponding
Digital Networking Architecture (DNA) Advantage license, you can configure the same using this task. Or
Command or Action
license smart usage interval interval_in_days
Example:
Device(config)# license smart usage
interval 40
exit
Example:
Device(config)# exit
copy running-config startup-config
Example:
Device# copy running-config
startup-config
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Configuring a License
Purpose
The no license smart url smartsmart_url
command reverts to the default URL.
• utility smart_url: Although available on
the CLI, this option is not supported.
(Optional) Sets the reporting interval in days.
By default the RUM report is sent every 30
days. The valid value range is 1 to 3650.
If you set the value to zero, RUM reports are
not sent, regardless of what the applied policy
specifies - this applies to topologies where
CSLU or CSSM may be on the receiving end.
If you set a value that is greater than zero and
the transport type is set to off, then, between
the interval_in_days and the policy value for
Ongoing reporting frequency(days):
lower of the two values is applied. For example,
if interval_in_days is set to 100, and the value
in the in the policy says
Ongoing reporting
, RUM reports are sent
frequency (days):90
every 90 days.
If you do not set an interval, and the default is
effective, the reporting interval is determined
entirely by the policy value. For example, if the
default value is effective and only unenforced
licenses are in use, if the policy states that
reporting is not required, then RUM reports are
not sent.
Exits global configuration mode and returns to
privileged EXEC mode.
Saves your entries in the configuration file.
, the
163