Mounting Model B; Mounting Model D; Mounting Model E; Mounting Model F - E+E Elektronik EE29 Series Manual

stainless steel mounting flange
13
bow for draining water
of condensation
vertical/horizontal mounting
Hardware
3.2 Mounting of model B (Duct mounting)
Transmitters of the EE29/31-xBx series are designed for duct mounting.
Working range: -40...80degC
i
3.3 Mounting of model D (Remote sensing probe)
Transmitters of the EE29/31-xDx series are transmitters with remote
sensing probes for measurements in the extended temperature range.
Working range of sensor probe: -40...180degC
Working range of electronics:
Mounting of the remote sensing probe (Series D):
Using the stainless steel mounting flange (refer to accessories) it is pos-
sible to mount the probe on the outer wall of the measuring chamber.
The depth of immersion is adjustable.
For roof installations use the drip water protection (refer to accessories)
to protect the sensor head and elements against condensed water.
i
drip water
protection
85
roof mounting
3.4 Mounting of model E (with pressure-tight sensor)
Transmitters of the EE29/31-xEx series are transmitters with remote,
pressure-tight sensor probes that are suitable for applications at
pressures between 0.01...15 bar
Working range temperature:
Working range of electronics:
i
3.5 Mounting of model F (Wall mounting with rear
cable outlet)
Transmitters of the EE29/31-xFx series are designed for wall mounting.
Cable entry is from the rear side (e.g.: clean-room applications...).
Working range: -40...60 degC
i
(-40...176°F)
with display: -20...50degC
The sensor probe must point horizontal or downwards in the
duct channel.
-40...60degC
with display: -20...50degC
The sensor probe must be mounted horizontally or vertically,
pointing downwards. When possible, a drip sheet should be
fitted for each mounting.
(0.15...218psi)
-40...180degC
pressure: 0.01...15 bar
-40...60degC
with display: -20...50degC
The sensor probe must be mounted horizontally or vertically
pointing downwards. Where possible, a drip sheet should be fit-
ted for each mounting.
(-40...140°F)
with display: -20...50degC
The transmitter must be mounted with the sensor probe pointing
downwards!
6
(-4...122°F)
(-40...356°F)
(-40...140°F)
(-4...122°F)
.
(-40...356°F)
(0.15...218psi)
(-40...140°F)
(-4...122°F)
(-4...122°F)