Sensor / Probe Replacement - E+E Elektronik EE29 Series Manual

Replacement - Humidity Sensor: 1) Open the configuration of the selected transmitter by clicking on the button
Replacement - Probe:
5.3

Sensor / Probe Replacement

In case of sensor or probe replacement, the characteristic values for this
sensor/probe must be saved in the transmitter, thereby the transmitter will operate
within the specified accuracy range without the need for costly recalibration.
"Read Transmitter".
2) Replace the humidity sensor by a new one (see Hardware, chapter 8.1
Sensor Replacement).
3) Enter the nominal capacity C76 and the humidity coefficient in the corresponding
input fields.
4) Save the settings by clicking on the button "Save Transmitter".
1) Open the configuration of the selected transmitter by clicking on the button
"Read Transmitter."
2) Replace the humidity sensor by a new one (see Hardware, chapter 8.2 Probe
Replacement.
3) Enter the nominal capacity C76, the humidity coefficient, the offset, the gain, the
resistor R0, the temperature coeffcients, and the resistor offset in the corresponding
input fields.
4) Save the settings by clicking on the button "Save Transmitter."
31
Configuration software