Table of Contents
Advertisement
4
Using a Phillips #1 screwdriver, install the screws that secure the control panel to the system.
Figure 114. Installing the left control panel
5
Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
Figure 115. Installing the cable cover
Next steps
1
Install the air shroud.
2
If applicable, install the cooling fan #1.
3
Follow the procedure listed in
Removing the right control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
Steps
1
Lift the cable latch and disconnect the control panel cable from the connector on the system board.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
165
Advertisement
Table of Contents
