Table of Contents
Advertisement
Next steps
1.
Replace the air
shroud.
2.
Replace front
bezel.
3. Follow the procedure listed in the
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the front
bezel.
4.
Remove the air
shroud.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
3. Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
80
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
