Table of Contents
Advertisement
To set the IP addresses:
1.
Click EDIT (see figure 32 [left],
Settings panel opens to allow edits (right).
Figure 32.
2.
Edit the network settings as desired:
a.
Click the DHCP switch (
the unit configures its IP address and other network settings from the DHCP server.
The default is Off.
b.
To set any of the addresses (IP Address (
address (
3.
When finished editing, click out of the field and click SAVE to confirm your changes or
CANCEL to close the window without making changes. Clicking the X in the upper-right
corner of the screen also closes the window.
Firmware Panel
The Firmware panel (see figure 29,
it was last updated. Update the firmware on the FOX3 T 201 from this panel (see
Firmware Installation
To update firmware:
In the Firmware panel, click the SELECT
1.
FILE button.
In the Open dialog box, browse to locate
2.
the new firmware file on your computer
(by default the file is stored at C:\
Program Files (x86)\Extron\Firmware\
FOX3 T 201 after being downloaded
from www.extron.com).
NOTE: Firmware files for FOX3 T 201 have a .eff extension. Do not attempt to load any
other file types.
) in the Network Settings panel. The Network
1
Network Settings Panel
) to toggle DHCP on and off. When DHCP is enabled (On),
2
), click in the desired field and enter the address.
5
) displays the current firmware version and the date
4
on page 26 to download the firmware files).
FOX3 T 201 Transmitter • Internal Web Page
), Subnet mask (
), and Gateway
3
4
Figure 33.
Firmware Panel
Software/
38
Advertisement
Table of Contents
