Table of Contents
Advertisement
SIS Configuration
and Control
This section describes the remote control operation of the FOX3 T 201 transmitter,
including:
•
•
•
The FOX3 transmitter can be configured using SIS commands, PCS, or embedded web
pages. The FOX3 transmitter can be controlled using SIS commands or PCS. Configure and
control the FOX3 transmitter remotely via a host computer or other device (such as a control
system) by connecting to the rear panel RS‑232 port, LAN port, or the front panel USB port.
Host Control Ports
Rear Panel RS-232 Port
The rear panel serial port (see
such as a computer running Extron DataViewer, available at www.extron.com. The port
makes serial control of the FOX3 device possible. Use the protocol information listed below
to make the connection.
The protocol for the serial ports is as follows:
•
•
Front Panel Configuration USB Port
The front panel mini B USB Configuration port (see figure 9,
connected to a host computer for configuration using SIS commands via an SSH client and
IP address 203.0.113.22 on port 22023.
Ethernet (LAN) Ports
The rear panel Ethernet connector (see
an Ethernet LAN or WAN. Communications between the transmitter and the controlling
device is via an SSH client using port 22023. This connection makes SIS control of the
unit possible using a computer connected to the same LAN or WAN (see
Termination and Recommendations
Host Control Ports
Simple Instruction Set Control
Command and Response Table for SIS Commands
figure 2
9600 baud
1 stop bit
FOX3 T 201 Transmitter • SIS Configuration and Control
on page 5) can be connected to a host device
•
no parity
•
no flow control
figure 2
on page 5) can be connected to
on page 11 to wire the LAN connector).
•
8 data bits
on page 12) can be
B
TP Cable
17
Advertisement
Table of Contents
