Table of Contents
Advertisement
Front Panel Features
A A
A
Figure 9.
A
B
C
Operation
After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
Configuration and operation of the transmitter is accomplished via
and Control
Configuration Software
Reset
The rear panel Reset button initiates three levels of resets (numbered 1, 4, and 5). Use a
pointed stylus, ballpoint pen, or small screwdriver to access the recessed button.
See the
ATTENTION:
SIGNAL
CONFIG
HDCP
B B
B
Transmitter Front Panel Features
Power LED — The unit is receiving power and is operational.
Configuration port — This USB mini-B port is used to configure the unit and to
update firmware.
Input LEDs
Signal — Lights when the unit detects an input video signal.
•
•
HDCP — Lights when the input signal is HDCP encrypted.
•
Digital Audio — Lights when digital audio is selected.
Analog Audio — Lights when analog audio input is selected.
•
transmitter and receiver, and power is applied to the FOX3 devices and the display
before power is applied to the video source. If the other devices are not turned on
before the video source, the image may not appear.
starting on page 17, the
starting on page 26.
Reset Modes
and
figure 10
Review the reset modes carefully. Some reset modes delete all user loaded
•
content and revert the device to default configuration.
•
Analysez minutieusement les différents modes de réinitialisation. Certains modes
de réinitialisation suppriment l'intégralité du contenu chargé de l'utilisateur et
remettent l'appareil au mode de configuration par défaut.
INPUT
DIGITAL AUDIO
ANALOG AUDIO
C
C C
Internal Web Page
starting on page 35, and
on page 13 for a summary of the resets.
FOX3 T 201 Transmitter • Installation and Operation
FOX3 T 201
SIS Configuration
12
Advertisement
Table of Contents
