Ds60 Cable Information; Sas I/O Module To Ds60 Connector; Cables For Node 0 And Node 1 To Ds60 Shelf Loop - Dell EMC Data Domain DD9800 Installation Manual

Installation and storage expansion guide

Hide thumbs Also See for EMC Data Domain DD9800:

Table of Contents

DS60 cable information

The primary and secondary nodes use the same cable type to connect to DS60 disk shelves.

Figure 67. SAS I/O module to DS60 connector

Table 19. Cables for node 0 and node 1 to DS60 shelf loop

HD-mini-SAS connector on controller and enclosure

Cable model code

XC-DS60-SAS-3M

XC-DS60-SAS-4M

XC-DS60-SAS-5M

CAUTION:

Observe the following considerations when cabling new shelves:

● Work on one SAS loop at a time.

● Allow at least eight minutes between each cable removal or insertion on a SAS I/O module in the Data Domain

controller to allow the Data Domain system to apply required firmware updates and device mapping on the

DS60 shelf.

● Verify all SAS cables are fully seated at both ends.

● If possible, utilize available SAS I/O module connections to add new storage enclosures.

Part number

038-004-380-01

038-000-212-00

038-000-214-00

Cable length

3 m (118 in)

4 m (158 in)

5 m (196 in)

Connect Cables and Power On

Table of Contents