Table of Contents
Advertisement
<AREA*P2>
+
5.9 Free plane limit
Defines any plane in the robot coordinate system, determines the front or back of the plane, and generates
a free plane limit error.
Ｐ２
Ｐ１
Parameter and value
SFCnP(n=1 to 8)
SFCnME(n=1 to 3)
SFCnAT(n=1 to 8)
After setting the parameters above, turn the controller's power ON again. This will allow the generation of
free plane limit error when it crosses the plane.
±0°
Example) If the value passes through 0 from -100 to +100,
Example) If the value passes through 180 from -100 to +100,
<AREA*P1>
-
±180°
P３
Specifies the 3 points that define the plane.
P1 coordinates X1, Y1, and Z1: The origin of the plane
P2 coordinates X2,Y2,Z2: A position on the X axis of the plane
P3 coordinates X3,Y3,Z3: A position in the positive Y direction of the X-Y plane in the plane
Specifies the mechanism number to which the free plane limit applies. Usually, set up 1.
In the case of multiple mechanisms, the mechanism numbers are specified.
Designate the valid/Invalid of the set free plane limit.
0:Invalid
1: Valid (The operable area is the robot coordinate origin side.)
-1: Valid (The operable area is the side where the robot coordinate origin does not exist. )
the following setting is necessity.
Sets the negative value to ABC of <AREA*P1>.
Sets the positive value to ABC of <AREA*P2>.
the following setting is necessity.
Sets the positive value to ABC of <AREA*P1>.
Sets the negative value to ABC of <AREA*P2>.
As can be seen in the diagram to the left, any
plane can be defined by three points (P1, P2, and
P3), after which an evaluation of which side of the
plane it is in (the side that includes the robot origin
or the other side) can be performed.
This function can be used to prevent collision with
the floor or interference with peripheral devices.
Maximum of eight planes can be monitored.
There is no limit to the plane.
Explanation
5Functions set with parameters
Free plane limit 5-368
Advertisement
Table of Contents
