Mitsubishi MELFA CR1D Instruction Manual page 371

Parameter
Parameter
name
Position DJNT
Restoration
Support
MEXDTL
MEXDTL1
MEXDTL2
MEXDTL3
MEXDTL4
MEXDBS
No. of arrays
No. of characters
Real value 8
The OP correction data obtained by the Position Restoration
Support tool is input. Do not change it with any tool other than the
Position Restoration Support tool. It can only be referenced on a
dedicated parameter screen in the Personal Computer Support
software.
Real value 6
The standard tool correction data obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
Real value 6
The correction data for tool number 1 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
Real value 6
The correction data for tool number 2 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
Real value 6
The correction data for tool number 3 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
Real value 6
The correction data for tool number obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
Real value 6
The correction data for the base obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
5Functions set with parameters
Details explanation Factory setting
It varies with models.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
Operation parameter 5-358