Mitsubishi MELFA CR1D Instruction Manual page 370

5Functions set with parameters
Parameter
Parameter
Restore the RESTORE
information on
the ROM to the
RAM.
Refer to Page
380, "5.18
About ROM
operation/high-
speed RAM
operation func-
tion".
Maintenance MFENA
forecast
Maintenance MFINTVL
forecast execu-
tion interval
Maintenance MFREPO
forecast
announcement
method
Resetting MFGRST
Maintenance
Forecast
Note)
When reading
this parameter
form the
teaching
MFBRST
pendant, enter
all parameter
names and
then read.
5-357 Operation parameter
No. of arrays
No. of characters
name
Character Restore the program, the parameter, the common variable, and the
string 1 error log to the RAM from the ROM.
Do not change this parameter.
Integer 1 This sets whether maintenance forecast is enabled or disabled.
1: Enable
0: Disable
Note) This function is limited to the RV-SD/RH-SDH series. This
parameter does not take effect on models that do not support the
maintenance forecast function.
Integer 2 This sets the interval of collecting data for maintenance forecast.
1st element: Data collection level -- 1 (lowest) to 5 (highest)
2nd element: Forecast check execution interval (unit: hours)
Integer 2 This sets the maintenance forecast announcement method. Set 0
in order to stop a warning or signal output.
1st element: 1: Generates a warning, 0: Does not generate a warn-
2nd element: 1: Outputs a dedicated signal, 0: Does not output a
Integer 1
Reset the accumulated data relating to grease in the maintenance
forecast function.
* When axes generated a warning (numbered in 7530's) that
prompts the replenishment of grease in the maintenance forecast
function and, as a result, grease was replenished, the data relating
to grease accumulated on the controller must be reset.
Generally, a reset operation is performed on the Maintenance
Forecast screen in Personal Computer Support software. However,
if a personal computer cannot be readied, the accumulated data
can be reset by entering this parameter from the teaching pendant
instead.
Integer 1
Reset the accumulated data relating to grease in the maintenance
forecast function.
* When axes generated a warning (numbered in 7530's) that
prompts the replacement of belt in the maintenance forecast
function and, as a result, the belt was replaced, the data relating to
the belt accumulated on the controller must be reset.
Generally, a reset operation is performed on the Maintenance
Forecast screen in Personal Computer Support software .
However, if a personal computer cannot be readied, the
accumulated data can be reset by entering this parameter from the
teaching pendant instead.
Details explanation
ing
dedicated signal
Factory setting
FLROM->SRAM
(unchangeable)
RV-SD/RH-SDH
series ........1
Except the
above...........0
1(lowest),6(hour)
0 (Does not gener-
ate a warning) ,
0 (Does not output
a signal)
0: Reset all axes.
1 to 8: Reset the
specification axis.
0: Reset all axes.
1 to 8: Reset the
specification axis.