Mitsubishi MELFA CR1D Instruction Manual page 44

3Explanation of operation methods
5) Registration of Step 1
Press the [EXE] key and register the step 1.
<PROGRAM> 1
1MOV P1
＿
Registration of Step 1 [EXE]
6) Hereafter, input Steps 2 and 3 in the same way.
<PROGRAM> 1
1 Mov P1
2 Mov P2
3 End
DELETE
EDIT
The input of the program was completed above.
◇◆◇ Displaying the previous and next command step ◇◆◇
Display the four lines on the screen of T/B. For moving the cursor to the front line, the [ ↑ ] key is pressed, for
moving the cursor to the next line, press the [ ↓ ] key, and select.
◇◆◇ Displaying a specific line ◇◆◇
Press the [FUNCTION] key, and change the function display, and press the [F2] key. The display changes to
the JUNP screen. The specification line can be displayed, if the step number to display in the parenthesis is
inputted and the [EXE] key is pressed.
◇◆◇ The step number can be omitted when inserting. ◇◆◇
It is inserted in the next of the cursor line if it omits.
◇◆◇ The capital letter and the small letter are changed automatically. ◇◆◇
Display the reserved word and the variable name in MELFA BASIC V combining the capital letter and the
small letter. Change automatically at the time of confirmation of the line also with the capital letter (with the
small letter) at the time of the input from TB.
3-31 Programming
Ins
123 CLOSE
50%
⇒
123 INSERT TEACH
<PROGRAM> 1
1Mov P1
DELETE 123
EDIT INSERT
50%
⇒
TEACH