Specifying Wan Settings - JDS Uniphase HST-3000 User Manual

Chapter 3 Data testing
Specifying test settings
Specifying
WAN settings
36
2 Select NAT to enable or disable network address transla-
tion (NAT) as appropriate.
Use this when the customer CPE modem/router assigns
private IP addresses.
3 Select Server IP, then enter the tester's LAN server IP
address.
4 Select Net Mask, then enter the LAN net mask address.
5 Select DHCP Server to enable or disable the tester's
DHCP server.
Enable the DHCP server when the customer's CPE is
configured to receive an IP address automatically.
6 If DHCP Server is enabled, perform the following steps:
a Enter the starting IP address for the tester's DHCP
server.
b Enter the pool size.
This is how many IP addresses the tester's DHCP
server may assign to other computers.
7 Select Media Type, then select the media type.
8 Select Forward Multicast, and then specify whether it is
enabled.
The LAN settings are specified.
The following procedure describes how to specify the wide
area network (WAN) settings. The WAN interface is the DSL
connection to tip and ring.
The WAN Settings menu appears if you are using IPoE or
Multi VLAN data mode. For Multi VLAN data mode, you may
have more than one WAN screen (for example, WAN2,
WAN3).
HST-3000 xDSL Testing User's Guide