Specifying Stun Settings - JDS Uniphase HST-3000 User Manual

Specifying
STUN settings
For this authentication, the HST acts as a supplicant. The
following procedure describes how to specify the 802.1x
settings.
To specify 802.1x settings
1 Press the 802.1x soft key. You may need to scroll left or
right to find it.
The 802.1x Settings screen appears.
2 Press 2 then enter the User Name.
3 Press 3 then enter the Password.
The 802.1x settings are specified.
On the main screen, a lock icon indicates whether you are
authenticated (indicated by a secured/closed lock) or unau-
thenticated (an open lock).
This screen is only available if you are using IPoE data mode
and "STUN Enabled" is set to "Yes" on the Data Settings
menu.
STUN (Simple Transversal of UDP [User Datagram Protocol]
Through NATs [Network Address Translators]) allows VoIP
calls across a NAT router. These settings should only be
changed if necessary.
HST-3000 xDSL Testing User's Guide
Chapter 3 Data testing
Specifying test settings
39