Specifying Lan Settings - JDS Uniphase HST-3000 User Manual

Specifying LAN
settings
5 If you are testing in IPoE data mode, select STUN
Enabled and then specify whether STUN is enabled.
6 If you are testing in Multi-VLAN data mode, select Inter-
face Count, and then enter the number of VLANs,
between 1 and 3.
Additional setup items appear for each VLAN: Interface
Mode and Interface Purpose.
7 If you are testing in Multi-VLAN data mode, select Inter-
face x Mode, and then specify the data mode for that
sub-interface (IPoE or PPPoE).
8 If you are testing in Multi-VLAN data mode, select Inter-
face x Purpose, and then specify the purpose for that
sub-interface (Internet, Video, or Voice).
9 Repeat steps
The data settings are specified.
The following procedure describes how to specify the LAN
settings. The LAN settings are only available in Through mode
(when the Data Emulation Type is set to Through).
To specify the LAN settings
1 Press the LAN soft key.
The LAN Settings menu appears.
HST-3000 xDSL Testing User's Guide
7 and 8 for any remaining interfaces.
Chapter 3 Data testing
Specifying test settings
35