Threshold Settings - JDS Uniphase HST-3000 User Manual

Threshold settings To specify threshold settings
Threshold
Up Rate H / L
Dn Rate H / L
Max Dn Rate H / L
Dn Capacity H / L
Dn Noise Margin H / L
20 Select Event Log Size, and then specify the size of the
event log. The size options are as follows: 100, 200, 300,
400, 500.
21 Select Cmptblty Flag and then specify whether a
message appears when a different version of modem
software is detected than was expected.
The general modem settings are specified.
1 Press the Configure
The parameter soft keys appear.
2 Press the GENERAL soft key.
The xDSL Thresholds menu appears.
3 Specify the thresholds. The following table describes the
thresholds.
Description
The high and low thresholds for the upstream rate.
The high and low thresholds for the downstream rate.
The high and low thresholds for the max downstream rate.
The high and low thresholds for the downstream capacity.
The high and low thresholds for the downstream noise
margin.
HST-3000 xDSL Testing User's Guide
Chapter 2 DSL Testing
Testing in single-line modem emulate mode
navigation key.
17