Specifying Wan Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 VDSL Testing
Testing Data services
Specifying WAN
settings
40
8 Select Forward Multicast, and then specify whether it is
enabled.
The LAN settings are specified.
The following procedure describes how to specify the wide
area network (WAN) settings. The WAN interface is the DSL
connection to tip and ring.
The WAN Settings menu appears if you are using IPoE or
Multi VLAN data mode. For Multi VLAN data mode, you may
have more than one WAN screen (for example, WAN2,
WAN3).
To specify the IPoE WAN settings
1 Press the WAN soft key.
The WAN Settings menu appears.
The menu items vary depending on the Data mode.
NOTE:
If you selected PPPoA or Bridged Ethernet as the Data
mode, the WAN settings are not applicable, and thus the
WAN tab is not displayed.
If you are using Multi VLAN data mode, the first item is
Interface Mode but is not selectable. It is auto populated
from the Data Settings menu "Interface x Mode" selection.
HST-3000 VDSL Testing User's Guide