Specifying Wan Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 IP Video Testing
Specifying test settings
Specifying WAN
settings
16
Client is normally used. Use Server only when you have
an ATU-C. This feature allows a remote ATU-R to estab-
lish a PPP session with the HST-3000.
NOTE:
If you selected "Server" as the PPP mode, connect only to
other devices with the same service name.
3 Select User Name, and then enter a valid user name.
This must be a valid user account with an ISP.
4 Select Use Provider, and then select either Yes or No.
This option indicates whether to append the user name
with the service provider domain name (for example,
earthlink.net). Select Yes only if user names for the ISP
must include the domain name as part of the user name.
This setting automatically appends the @ sign for you.
5 Select Provider, and then enter the provider name.
This is required if you selected Yes for "Use Provider."
6 Select Password, and then enter the user password.
This must be a valid password that matches the user
name above. Passwords are often case-sensitive.
7 Select Use Service Name.
This selection allows you to request a specific service, by
name.
8 If you selected "Yes" for Use Service Name, enter the
Service Name, up to 50 characters.
The PPP settings are specified.
The following procedure describes how to specify the wide
area network (WAN) settings. The WAN interface is the DSL
connection to tip and ring.
HST-3000 IP Video Testing User's Guide