Installing The Processor Through A Wall - Dryer End - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Installing the PROCESSOR Through a Wall — Dryer End
LIGHTTIGHT
GASKET
PROCESSOR
FLOOR
PLATE
LEVELING SCREW
WALL
PANEL
ANGLE
BRACKETS
LIGHTTIGHT
GASKET
H148_0077ACA
H148_0077AA
12
BAR
LIGHT-
TIGHT
GASKET
ANGLE BRACKET
LIGHTTIGHT
GASKET
BAR
H148_0078CCA
H148_0078CA
BAR
Note
• See Page 11 for Feed End installation through the
wall.
• The customer is responsible for preparing a hole in
the wall of the correct size to install the
PROCESSOR. Refer to the Site Specifications,
Publication Part No. 5B6338.
• For Dryer End installation through the wall, order
Kodak X-Omat THROUGH-THE-WALL LIGHT-
LOCK KIT, CAT No. 898 0815.
Caution
Do not stretch the LIGHTTIGHT GASKET.
[1] Install the self-adhesive LIGHTTIGHT GASKET
onto the ANGLE BRACKETS.
(a) Cut strips of GASKET for each of the
3 edges of the ANGLE BRACKETS. See
the figure.
(b) Cut 2 strips of GASKET for the top and
bottom of the BAR.
[2] Attach the ANGLE BRACKETS to the wall.
[3] Move the PROCESSOR within approximately
2.5 cm (1 in.) of the wall.
[4] Install the 4 FLOOR PLATES under the
4 LEVELING SCREWS. FLOOR PLATES are
available for the 3/8-in. LEVELING SCREWS only.
If installing a SEISMIC KIT, use the FLOOR
PLATES provided with the SEISMIC KIT.
[5] If you are also installing a Kodak 5000 RA
INTEGRATED CHEMICAL MIXER, install it now.
See the Installation Instructions in the Service
Manual for the MIXER, Publication Part
No. 5B6727.
[6] Level the PROCESSOR. See Page 13.
[7] Adjust the ANGLE BRACKETS until the
LIGHTTIGHT GASKET is compressed against
the PROCESSOR to approximately 10 mm
(3/8 in.).
[8] Tighten the 9 SCREWS.
[9] Check that the LIGHTTIGHT GASKET is tight
against the PROCESSOR.
[10] Place the BAR under the PROCESSOR.
[11] Check for light leakage around the PROCESSOR.
January 1996 – 5B6339