Removing The Processor From The Pallet - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

INSTALLATION INSTRUCTIONS
DEVELOPER RACK
H148_0010BCB
H148_0010BA
[5] Remove the RACKS and the plastic packing material.

Removing the PROCESSOR from the PALLET

2 BOLTS
nondrive
side
H148_0175GCA
H148_0175GA
6
FIXER RACK
TOP COVER
drive
side
PALLET
RAIL
WASH RACK
Warning
• The PROCESSOR weighs over 227 kg (500 lb).
Use 2 persons when installing the LEVELING
SCREWS and moving the PROCESSOR into
position.
• The PROCESSOR is not fastened to the PALLET.
Be careful when moving the PALLET.
[1] Move the PROCESSOR, on the PALLET, as close
as possible to the installation site.
Note
The following steps are for moving the PROCESSOR
off the drive side of the PALLET, but if access is easier
on the nondrive side of the PROCESSOR, remove the
BOLTS and RAIL from the nondrive side of the
PALLET.
[2] Move the PROCESSOR toward the nondrive side
until the nondrive side of the PROCESSOR is
flush with the nondrive edge of the PALLET.
[3] Remove the 2 BOLTS and the RAIL that is under
the drive side of the PALLET.
January 1996 – 5B6339