Installing The Leveling Screws - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

INSTALLATION INSTRUCTIONS
SLIDE
H148_0177GCA
H148_0177GA

Installing the LEVELING SCREWS

H148_0184ACA
H148_0184AA
10
ELECTRICAL
BOX
drive side
SHIPPING
SCREW
LEVELING
SCREW
[7] Remove the SHIPPING SCREW from the drive
side ELECTRICAL BOX SLIDE.
[8] Remove the tape from the ELECTRICAL BOX.
Caution
Tilting the PROCESSOR from front to back may cause
damage to the PANELS of the PROCESSOR. To
install the LEVELING SCREWS, tilt the PROCESSOR
from side to side.
[1] Tilt the PROCESSOR to the drive side, and install
the 2 nondrive side LEVELING SCREWS.
[2] Rotate the LEVELING SCREWS fully up.
[3] Tilt the PROCESSOR to the nondrive side and
install the other 2 LEVELING SCREWS, and
rotate fully up.
January 1996 – 5B6339