Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual page 37

[2] If a "?" is displayed, check that the 6000 BOARD HOUSING is free of dirt or chemical deposits.
(a) Clean if necessary with a clean, damp synthetic sponge.
(b) Check again for correct operation. If not, install a new 6000 BOARD.
Note
For correct Film Logging, all 22 LEDs must operate correctly. A "?" displayed during the Film Accumulator Test
indicates a malfunctioning LED. A "+" displayed indicates a correctly operating LED.
Film Width Film Width
cm
10 cm 4 in.
5 in.
6.5 in.
18 cm 7 in.
8 in.
8.5 in.
24 cm
10 in.
11 in.
30 cm 12 in.
35 cm 14 in.
40 cm
43 cm 17 in.
5B6339 – January 1996
LEDs
inches Covered
5
6
8
9
10
11
12
13
14
15
18
20
22
Installing and Adjusting the FEED TRAY
[3] Chose a sheet of film of the size most often
processed, and place it on the FILM GUIDE with
the edge of the film aligned along the nondrive
edge of the FILM GUIDE.
[4] Adjust the FILM GUIDE until the correct number of
LEDs or "+" pluses for that size of film are
displayed. See the table at the left.
[5] Move the film to the drive side edge of the FILM
GUIDE and do Step
[6] Check that this adjustment is correct by doing
Steps 3 - 5 for each film size to be processed in
this PROCESSOR.
[7] Tighten the WING NUTS.
[8] Exit diagnostics.
Note
To ensure accuracy of the Film Logging feature, check
the operation of the 6000 FILM ACCUMULATOR
BOARD monthly, using the diagnostics.
4 again.
37