Table of Contents
Advertisement
[13]
From the non-drive side of the PROCESSOR, remove the CARDBOARD securing the ends of the
DRYER ROLLERS.
[14]
Remove the 10 AIR TUBES, on the outside of the DRYER, to access the PACKING MATERIAL around
the SHAFTS of the DRYER ROLLERS.
[15]
Remove the PACKING MATERIAL.
[16]
Insert the 10 AIR TUBES into the side of the DRYER. Place the flat side of the AIR TUBES up.
If you are unpacking the PROCESSOR anywhere other than in its final destination, make sure to
either install all removed parts or pack them carefully with the PROCESSOR for transport.
1C0932
DRYER
AIR TUBES
CARDBOARD
Figure 6 Removing Cardboard from the Dryer Air Tubes
PACKING
MATERIAL
NOTE
DRYER ROLLERS
H108_0299BCB
H108_0299BA
9
Advertisement
Table of Contents
