Kodak X-Omat 480 RA Processor Installation Instructions Manual page 36

Installing the Grommets and Replenishment Tubes
Prevent contaminating the processing solutions. Do the following procedure to connect the
DEVELOPER REPLENISHMENT TUBE to the DEVELOPER REPLENISHMENT TANK, then, do
the same procedure to connect the FIXER REPLENISHMENT TUBE.
[1] Insert the REPLENISHMENT TUBE through
one of the SLOTS in the feed end of the
PROCESSOR. See Figure ??. (The tubing is
not supplied.)
• Only thick-walled TUBING will
withstand the high suction of the
REPLENISHMENT PUMPS.
• REPLENISHMENT TUBES may instead be
inserted into the holes in the bottom of the
PROCESSOR. For additional information,
see the procedure on page ??.
[2] Install a GROMMET onto the
REPLENISHMENT TUBE. If necessary,
remove a section of the GROMMET.
[3] Compress the GROMMET and insert it into
the SLOT.
36
NOTE
GROMMETS
Figure 43 Installing the Grommets Into the Slots
SLOTS
SECTION
H108_0016CCA
H108_0016CA
1C0932