Table of Contents
Advertisement
The information contained herein is based on the experience and knowledge relating to the subject matter gained by
Eastman Kodak Company prior to publication.
No patent license is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and makes no warranty, express
or implied, with respect to this information. Kodak shall not be liable for any loss or damage, including consequential or
special damages, resulting from the use of this information, even if loss or damage is caused by Kodak's negligence or
other fault.
This equipment includes parts and assemblies sensitive to damage from electrostatic discharge. Use
caution to prevent damage during all service procedures.
To avoid hazardous conditions, keep floors and floor coverings around your Kodak X-Omat
Processors and associated drains clean and dry at all times. Any accumulation of fluids from
mixing tanks, drain lines, etc., should be cleaned up immediately. In the event of an accumulation
of liquid due to backup, overflow, or other malfunctions of the drain associated with your X-Omat
Processor, call a plumber or other contractor to correct any problem with the drain. Kodak
accepts no responsibility or liability whatsoever for the serviceability of any drain connected to or
associated with a Kodak X-Omat Processor. Such drains are the sole responsibility of the
customer.
If local codes require seismic mountings, order SEISMIC KIT 261413. The SEISMIC KIT includes
all parts necessary to secure one PROCESSOR.
2
PLEASE NOTE
IMPORTANT
1C0932
Advertisement
Table of Contents
