Table of Contents
Advertisement
Moving the Processor into Position
[1]
Move the PROCESSOR within approximately
2.5 cm (1 in.) of the wall.
[2]
Install the 4 FLOOR PLATES under the 4
LEVELING SCREWS.
If installing a SEISMIC KIT, use the
FLOOR PLATES provided with the
SEISMIC KIT.
[3]
Check that the LIGHT-TIGHT GASKET is tight
against the wall. Compress the LIGHT-TIGHT
GASKET to approximately 10 mm ( ⁄
1C0932
NOTE
3
in.).
8
2.5cm (1 in.)
PROCESSOR
Figure 15 Positioning the Processor
Figure 16 Installing the Floor Hardware
WALL
H108_0031ACA
H108_0031AA
LEVELING
SCREW
FLOOR
PLATE
H108_0037ACA
H108_0037AA
15
Advertisement
Table of Contents
