Table of Contents
Advertisement
[2]
Install the FILM GUIDE. Use the following, but do not tighten the WING NUTS.
• 3 WASHERS
• 3 WING NUTS.
WING NUT (3)
SCREW (5)
Adjusting the Height of the Feed Shelf
[1]
Adjust the position of the FEED SHELF so
that it is approximately 1 mm (1/16 in.) lower
than and parallel to the NIP of the
DETECTOR CROSSOVER ROLLERS.
[2]
When the height is adjusted correctly, tighten
the 5 SCREWS as shown.
Do not tighten the WING NUTS.
1C0932
FEED SHELF
Figure 11 Installing the Feed Shelf
NOTE
FILM
GUIDE
LOCKWASHER (5)
SCREW (5)
1mm (1/16 in.)
Figure 12 Adjusting the Feed Shelf
WASHER (5)
H108_0033BCA
H108_0033BA
DETECTOR
CROSSOVER
ENTRANCE
ROLLERS
NIP
SCREW (4)
H108_0038ACA
H108_0038AA
13
Advertisement
Table of Contents
