Table of Contents
Advertisement
Final Steps
[1]
Deenergize the PROCESSOR by moving the
MAIN CIRCUIT BREAKER CB1 to the ''O''
position.
[2]
Drain the TANKS of water by opening the
FIXER and DEVELOPER DRAIN VALVES.
[3]
Close the FIXER and DEVELOPER DRAIN
VALVES.
[4]
Install the 6 ACCESS PANELS.
[5]
Do the setup procedures. See the ''Setting
up the Processor'' section of the Operator
Manual.
IMPORTANT
After the PROCESSOR has been in
regular use for 1 or 2 days, again
check all fittings for leakage. If
necessary, tighten any loose
connections.
3228II_A.TXT
44
MAIN CIRCUIT
BREAKER CB1
FIXER
DRAIN VALVE
Figure 50 Feed-End View of Processor
DEVELOPER
DRAIN VALVE
H108_0002CCE
H108_0320CA
1C0932
Advertisement
Table of Contents
