Kodak X-Omat 480 RA Processor Installation Instructions Manual page 11

[2] Remove the FEED-END, LOWER ACCESS PANEL and the 2 side ACCESS PANELS from the
PROCESSOR for easier access.
[3] Move the PROCESSOR so that one corner is off the SKID.
To prevent damage the LEVELING SCREWS and the PROCESSOR during installation, do not
allow more than a 2.5 cm (1 in.) clearance between the bottom of the PROCESSOR and the
HEAD of the LEVELING SCREW.
[4] Insert a LEVELING SCREW into the corner of the PROCESSOR that is off the SKID.
[5] Move another corner of the PROCESSOR from the SKID.
[6] Insert a LEVELING SCREW into that corner of the PROCESSOR.
[7] Remove the PROCESSOR from the SKID.
[8] Carefully install the remaining 2 LEVELING SCREWS.
1C0932
LEVELING
SCREW
HEAD
Figure 8 Leveling Screw
H108_0036ACA
H108_0036AA
11