Flag0 Enable Jumper (Jp4); Flag1 Enable Jumper (Jp5); Sample Frequency Jumper (Jp6) - Analog Devices EZ-KIT Lite Manual

Table 2-1. SPDIF Modes
Jumper Location
1 and 2
2 and 3
Table 2-2. MCLK Selection
Jumper Location
1 and 2
2 and 3

FLAG0 Enable Jumper (JP4)

In standard configuration,
a select for the SPI port. This jumper should be removed to use the push
button switch or the signal on the expansion connector (
jumper is removed, the SPI can no longer communicate with the
AD1836.

FLAG1 Enable Jumper (JP5)

In standard configuration,
a select for the SPI port. The
push button switch or the signal on the expansion connector (
the jumper is removed, the SPI can no longer communicate with the
AD1852.

Sample Frequency Jumper (JP6)

The jumper is used to select the sample frequency for the AD1852
JP6
device. Table 2-3
ADSP-21161N EZ-KIT Lite Evaluation System Manual
EZ-KIT Lite Hardware Reference
Mode
Optical (factory default)
Coax
MCLK Source
Audio Oscillator (12.288 MHz) (factory default)
Derived clock from SPDIF Stream
is connected to the AD1836 and used as
FLAG0
is connected to the AD1852 and used as
FLAG1
jumper should be removed to use the
JP5
shows the valid frequency modes.
). Once the
P10
). Once
P10
2-7