Troubleshooting - Bosch Rexroth Automax 100 Series Operating Instructions Manual

Table of Contents

Advertisement

Troubleshooting measures
Fault
No function of basic module
No voltage at the safety sockets
+24V/U
at the top of the basic
A
module
1)
Depending on the application, the connector XVB-4/19 may not be needed
Troubleshooting | Automax 100 | Basic module TS-AC B1-M2-1X

Troubleshooting

Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
 Chapter
„Safety
instructions" as of page [7] in these operating instructions must
always be observed!
Property damage due to improper handling!
Improper handling can lead to damage or defects at the device!
 Ensure correct polarity of connections. Observe the color coding!
 Any troubleshooting and measures in case of faults must be carried out without any
mechanical force.
Cause of error
The external power supply unit is not connected
to any voltage supply
No voltage supply
Device fuse defective at basic module
The input voltage at the basic module is
incorrectly connected
The safety sockets „-1XG4" and „+24V/U
not bridged via „connector XVB-4/19"
In case of any problems identifying the cause of the error, please contact Bosch Rexroth
customer service.
Contact details can be found in chapter
WARNING
CAUTION
Measures
Connect the external power supply unit to a suitable
supply network. ATTENTION! The specification of
the input voltage of the used external power supply
unit must be observed.
Check the output voltage (DC 24 V) of the external
power supply unit by means of a multimeter.
As necessary, check the fuse protection of the
output voltage of the external power supply unit.
If the power supply unit has a main switch, check if
it is activated.
Check the micro-fuse on the front of the basic
module (5x20 mm / 6.3 A).
Check correct polarity of the supply voltage.
" are
Connect the safety sockets
A
1)
.
„-1XG4" and „+24V/U
„Contact
addresses" as of page [53].
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
45/54
" via „connector XVB-4/19".
A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Basic module ts-ac b1-m2-1x

Table of Contents