Bosch Rexroth Automax 100 Series Operating Instructions Manual page 15

Safety instructions | Automax 100 | Basic module TS-AC B1-M2-1X 11/54
Basic module with extension module Worktable
Operator workplaces (dimensions in cm)
Table rows can also be arranged inside a training room. If the table width is sufficient, the
tables can also be directly placed next to each other. If several rows of tables are in place, a
passage width of 100-200 cm must be ensured between the table rows. Escape routes must
be generally kept free and may not be obstructed. No cables should be routed on the
ground in the passages. If this is not possible, the cables must be covered with suitable
cable ducts or similar. If cable ducts are installed on the floor within the passage areas, a
„Tripping hazard" warning sign must be attached. Please refer to the table „Warning signs
according to DIN EN ISO 7010 (2019)" as of page [11].
The tables can also be arranged opposite of each other. Table rows can also be arranged
opposite of each other. This worktable arrangement must also comply with the above
criteria. See the following figure.
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P