Assembly; Unboxing The Product - Bosch Rexroth Automax 100 Series Operating Instructions Manual

Assembly | Automax 100 | Basic module TS-AC B1-M2-1X

Assembly

7.1

Unboxing the product

Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
 Chapter
„Safety instructions" as of page [7] in these operating instructions must
always be observed!
Danger due to parts falling out!
If the packaging is opened improperly, parts may fall out and cause damage or injuries.
 Put the packaging for unpacking on level, bearing ground
 Use personal protective equipment
Danger due to sharp and pointed packaging components
In case of improper handling, sharp and pointed parts of the packaging may cause injuries.
 Open the packaging using suitable aids
 Do not use sharp blades. Internal parts might be damaged
For unboxing of the device, proceed as follows:
 Carefully remove the basic module TS-AC B1-M2-1X from its packaging
 Remove all remaining packaging
Keep the original packaging during the guarantee period of the device for proper packaging
and return in case of any guarantee claims.
Damage caused during transportation and defects shall be promptly recorded with a photo
and reported in writing to the Bosch Rexroth customer service by way of a notification of
claim.
Disposal of packaging material:
The packaging material has been selected for environmental compatibility. Dispose of the
packaging material in accordance with the national regulations in your country and/or your
company-internal specifications/procedures.
DANGER
CAUTION
CAUTION
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
25/54