Extension And Modification; Extension By 1 Level - Bosch Rexroth Automax 100 Series Operating Instructions Manual

Extension and modification | Automax 100 | Basic module TS-AC B1-M2-1X

Extension and modification

Extension of the basic module is described in the following chapter. For information on
attachment and electrical connection, refer to the operating instructions of the respective
extension module.

13.1 Extension by 1 level

For connection of extension modules, 2 slots are available. The extension modules can be
plugged in and secured with knurled screws. The following figure illustrates the different
fitting types.
Fitting type 1
Fitting type 2
Fitting type 1 level
Fitting type 1
Slot 1 (front) of the basic module is fitted with an extension module. Voltage supply is
established via the safety sockets assigned to slot 1.
Fitting type 2
Slot 2 (rear) of the basic module is fitted with an extension module. Voltage supply is also
established via the safety sockets assigned to slot 1.
Fitting type 3
Both slots of the basic modules are fitted with extension modules. The extension module in
slot 2, however, is installed towards the rear (turned). Thanks to this arrangement, the M12
system connectors are not obstructed.
Fitting type 3
Fitting type 4
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
43/54