Table of Contents
Advertisement
Maintenance and repair | Automax 100 | Basic module TS-AC B1-M2-1X
Maintenance and repair
Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
Chapter
„Safety
instructions" as of page [7] in these operating instructions must
always be observed!
Maintenance must be carried out by qualified personnel. Information can be found in chapter
„Qualification of
personnel" as of page [8].
For repair, please contact Bosch Rexroth customer service.
10.1 Cleaning and care
For cleaning of the basic module, observe the following points:
With minor contamination (e.g. with dust), it is sufficient to wipe the component with a
microfiber cloth
For more stubborn contamination, use a damp cloth
Do not use solvents or aggressive cleaning agents which may damage the painted
surfaces
Ensure that no liquids enter the housing through the ventilation slots
Do not use compressed air for cleaning
10.2 Maintenance
Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
Chapter
„Safety
instructions" as of page [7] in these operating instructions must
always be observed!
To keep the basic module TS-AC B1-M2-1X in an operational condition, all electrical
equipment must be checked for defects or wear at regular intervals. Any defects or faults
detected must be rectified immediately.
CAUTION! Maintenance and repair work may only be carried out by personnel qualified to
do so. Information on this can be found in the chapter
[8]. Only original spare parts may be used to eliminate defects.
If in doubt, please contact our Service and Support. Contact persons and addresses can be
found in the chapter
„Service and
WARNING
WARNING
„Qualification of
support" as of page [53].
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
37/54
personnel" as of page
Advertisement
Table of Contents
