Assembling The Product - Bosch Rexroth Automax 100 Series Operating Instructions Manual

Optional power supply unit
Assembly | Automax 100 | Basic module TS-AC B1-M2-1X
Accessories required for assembly
Quantity Mat.-no.
1 R961008981
For voltage supply of the basic module, also power supply units of other suppliers can be
used. The following table provides the specifications to be met by a power supply unit of
another supplier.
Power supply unit specification
Designation
Input data
Output data
1) Input voltage and input frequency depend on the power supply ratings of the respective country. For this reason, they
may deviate from the specified values.
2) For operation of the basic module up to its performance limit, the specified values are recommended by Bosch Rexroth.
Compliance with national regulations and standards is within the responsibility of the
operator. Bosch Rexroth AG does not assume any liability for damage caused by use of
power supply units from other suppliers. The operator assumes all risks involved with the
use of power supply units from other suppliers.
7.4

Assembling the product

Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
 Chapter „Safety instructions" as of page [7] in these operating instructions must
always be observed!
In case of damage, wear and/or contamination of the safety socket, functional safety
of the plug-in connection can be no longer ensured!
Risk of damage of the basic module TS-AC B1-M2-1X, malfunction!
 Check the safety sockets by visual inspection for wear and contamination
 Remove any contamination on surfaces
Designation
Power supply unit 230 V, 10 A
Input voltage: AC 230 V, 50-60 Hz
Output voltage: DC 24 V, 10 A
Designation
EN61000-3-2 (PFC standard)
AC input voltage
AC input frequency
DC output voltage
Output current
Output power
DANGER
NOTICE
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
27/54
Unit Value
--- complied with
1)
VAC 100-240
1)
Hz 50-60
VDC 24 / ±10%
2)
ADC 6,5
W 156 2)