Voltage Supply, General Information - Bosch Rexroth Automax 100 Series Operating Instructions Manual

18/54 About this product | Automax 100 | Basic module TS-AC B1-M2-1X
Description of the operating
equipment at the front plate
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
Basic module TS-AC B1-M2-1X with extension module TS-AC E2-M3-1X
The front of the basic module includes a main switch, an electric fuse and an Ethernet
switch.
The main switch interrupts the supply voltage to the Ethernet switch and the safety sockets
at the top of the module.
The voltage U is protected via the device fuse.
LS
Basic module front plate
Main switch
Device guse (5x20mm)
Operating equipment on front plate
5.2.1

Voltage supply, general information

The voltage supply on the rear of the basic module TS-AC B1-M2-1X is divided as follows:
 Voltage supply for sensors and logics (e.g. PLC) – U
(red safety socket)
 Voltage supply for actuator technology - U
(green safety socket)
 Ground (0V) – GND
 (blue safety socket)
If no external voltage supply is required for the actuator technology (U
be plugged in. This way, the supply voltage U
socket (-1XG4)
ATTENTION! For external voltage supply of the actuator technology (U
from this series of training systems may be used.
NETGEAR Ethernet-switch
Knurled screw for securing of attached
extension modules
LS
A
), connector  must
A
is bridged to voltage U
LS A
A
via the black safety
), only modules