Extension By 2 Levels; Product Rebuild - Bosch Rexroth Automax 100 Series Operating Instructions Manual

44/54 Extension and modification | Automax 100 | Basic module TS-AC B1-M2-1X
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
Fitting type 4
Both slots of the basic modules are fitted with extension modules. The extension module in
slot 2 is installed towards the front. For simultaneous operation of both extension modules,
this type cannot be recommended. Access to the M12 system connectors at module 2 is
highly restricted. However, slot 2 can be used as parking position for modules which are not
required.

13.2 Extension by 2 levels

Additional fitting types concern stacking of multiple extension modules.
Attention! Stacking of more than two extension modules is not recommended as this would
compromise the stability (risk of tilting).
Fitting type 5
Fitting type 2 levels
Fitting type 5
Slot 2 of the basic module is fitted with an extension module. A second extension module is
then placed on the previously installed extension module. This fitting types offers the
advantage that all M12 system connectors can be easily reached and all status indicators of
the installed components are visible from the front.
Fitting type 6
Attention! If several extension modules are stacked, slot 1 of the basic module must not be
used (risk of tilting).

13.3 Product rebuild

If the basic module TS-AC B1-M2-1X has already been equipped with an extension module,
the extension module is removed in the reverse order as described in the chapters
„Extension by 1 level" as of page [45] and
Fitting type 6
„Extension by 2 level" as of page [46].