Safety Signs - Bosch Rexroth Automax 100 Series Operating Instructions Manual

Safety instructions | Automax 100 | Basic module TS-AC B1-M2-1X
 Observation and use of the operating instructions as well as the legal provisions
 Intended operation of the Bosch Rexroth product
 Observation of the instructions from the factory security offices as well as the operator's
operating instructions
 Behavior in case of emergency
The operator has to guarantee the required prerequisites for the set-up and the installation
of the product and provides for:
 Safe set-up by their personnel and/or the persons authorized by them
 Compliance with the accident prevention regulations (UVV)
 Compliance with the safety regulations of the professional unions as well as further
internal and local requirements
He shall in particular make sure that the underground
 Is stable
 Is level and horizontal
The operator will instruct their employees and/or those of third-party companies on possible
dangers at the place of installation.
The operator must provide adequate illumination around the area of installation of the
product.
2.8.2

Safety signs

Depending on the installation conditions, it may be necessary to attach warnings at the
place of installation. The operator is responsible for attaching the safety signs.
For a recommendation regarding warnings, please refer to the following table.
Prohibitory signs according to DIN EN ISO 7010 (2019)
Symbol Description
Open flames, fire, open ignition sources and smoking prohibited
Registration number: P003
Do not extinguish with water
Registration number: P011
Warning signs according to DIN EN ISO 7010 (2019)
Symbol Description
Warning! Hot surface
Registration number: W017
Warning! Obstacles on the floor
Registration number: W007
Mandatory signs according to DIN EN ISO 7010 (2019)
Symbol Description
Observe operating instructions
Registration number: M002
Wear safety footwear
Registration number: M008
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
9/54